❄️Redo: Desktop Experiment #1 (Initial Planning): Experiment Design: Demonstrating Negentropic Energy Harvesting via Golden Ratio Implosion Using the Super Golden TOE❄️

Experiment Design: Demonstrating Negentropic Energy Harvesting via Golden Ratio Implosion Using the Super Golden TOE

Dan Winter note:

"energy harvesting should mention HOW the perfect planckphire.com tuned PHASE CONJUGATE PUMP WAVE - implosion /charge collapse ( www.pyramidwirelesspower.com ) is key to all zero point tech www.fractalfield.com/vacuumenergy (Bearden was right about the pump wave, but did not know how to correctly tune it.."

Objective: This desktop experiment demonstrates energy harvesting through negentropic (entropy-reversing) charge implosion, a core principle of the Super Golden Theory of Everything (TOE). Based on the TOE's axioms (e.g., Golden Ratio φ ≈ 1.618 optimizes constructive wave interference; charge collapse generates negentropy), the setup uses a φ-proportioned spiral coil and phase conjugate materials to create a centripetal field, theoretically harvesting Zero Point Energy (ZPE) from vacuum fluctuations. The "harvesting" is measured as induced voltage or enhanced plant growth (e.g., seed germination rate), simulating TOE applications like TheraPhi plasma rejuvenation or Imploder water treatment. Expected: ~10-20% efficiency gain in output vs. input, attributed to fractal compression (not true overunity, but illustrative of negentropy).

Scientific Basis per TOE: The experiment leverages Planckphire scaling (Planck unit × φ^N) for coil geometry, creating implosive fields that conjugate phases for negentropic gain, as in Dan Winter's models where φ-heterodyning multiplies wave velocities for energy extraction. This ties to action S equation by optimizing φ ds paths for minimal entropy in energy flow.

Materials (Desktop-scale, ~$20-50; assumes basic tools like multimeter for voltage measurement):

• Golden Ratio spiral coil: Enameled copper wire (~50 feet, 18-22 gauge) wound into a logarithmic spiral (radii increasing by φ: start at 1 inch, then 1.618, 2.618, etc., up to ~8 turns).
• Phase conjugate dielectric: Quartz crystal or fiber optic rod (~3-6 inches, placed at coil center for vacuum coherence).
• Magnets: 4-6 neodymium discs (1 inch diameter) arranged in φ-spaced groups around the coil for magnetic implosion.
• Capacitor bank: 2-4 capacitors (100-1000 μF) connected in parallel for charge storage.
• Input source: 9V battery or hand-crank generator for initial pulse.
• Measurement tools: Multimeter (for voltage/current output), seeds/plants (e.g., radish seeds in water for growth test).
• Base: Wooden/plastic board (~12x12 inches) and glue for assembly.

Step-by-Step Procedure:

1. Prepare the Spiral Coil: Wind the wire into a flat golden ratio spiral (use a template: draw concentric circles with radii r_n = r_{n-1} × φ, starting r_0=1 inch). Secure on the base board. This geometry optimizes wave interference for charge compression.
2. Integrate Phase Conjugate Core: Place the quartz crystal vertically at the spiral's center (glue if needed). Connect thinner wire ends around it for a small central coil (~10 turns), linking to the main spiral.
3. Add Magnetic Implosion: Position magnets around the spiral in a φ-pattern (e.g., at angles 0°, 137.5°—the golden angle ≈360°/φ—for 4 magnets), like poles facing inward to create centripetal fields.
4. Connect Energy Storage: Wire the spiral coil ends to the capacitor bank in series, forming a resonant circuit tuned to φ-related frequencies (e.g., ~53 Hz for bliss harmonics per TOE).
5. Setup Harvesting Measurement: For voltage: Connect multimeter across capacitors. For growth: Place seeds in a water dish near the coil vs. control dish away; expose to field for 24-48 hours.
6. Activate and Observe: Give initial pulse (battery ~1-2 seconds or crank spin). Measure output: Induced voltage (~0.1-1V expected from field collapse) or germination rate (~20% faster in exposed seeds, per Imploder claims).
7. Data Collection: Record baseline (no field) vs. active; repeat 5-10 trials. Simulate TOE fractality by varying coil turns in φ increments.

Expected Results and Analysis:

• Voltage Harvesting: ~0.5V sustained output from implosion (negentropic gain via phase conjugation), higher than input decay rate, demonstrating ZPE-like extraction.
• Growth Enhancement: Exposed seeds show 15-30% faster sprouting, attributed to bioactive negentropic fields (as in TOE's Imploder experiments).
• TOE Tie-In: Results validate Axiom 1 (φ interference) and Axiom 2 (charge collapse for negentropy), with action S minimizing entropy in the energy path.
• Controls and Safety: Use shielded area; compare with non-φ coil. No high voltages expected, but monitor for heat.

This experiment provides tangible demonstration of TOE energy principles, scalable to applications like TheraPhi. If results exceed expectations, document for further analysis.

I'll be using one of Dan's Phire Crystals* to do a few desktop experiments, this being one:

* Early work with the Phire Crystal, I/we am noting a harmonizing effect while handling the crystal, anecdotal, not scientific!

Enameled copper wire can be found anywhere, same for more other parts. The proper implosion angle symetry crystal is needed, that's why I am working with one of Dan's which should have the proper geometry, will be measuring. This is not a flash bang 💥 Pop desktop experiment...